Choosing The Output Wiring Mode; Setting The Probe Parameters Of The 8202; Activating/Deactivating The Hold Function - bürkert 8222 Schnellstartanleitung

Type 8202/8222
Adjustmentandcommissioning
9.7. choosing the output wiring
mode
The setting has no effect on a version with one fixed
connector, if the sole current output is wired.
Param Outputs
This is
This is
when the
device is be- when the
ing parame- device is be-
tered............ ing parame-
.................... tered............
....................
9.8. setting the probe parameters of
the 8202
The monitoring of the redox ("ORP") sensor is impossible if
the measurement mode is set to "asymmetrical".
Param Sensor
This is
This is
when the
when the
device is be-
device is be-
ing parame-
ing parame-
tered............
tered............
.................... ....................
HWMode source/PNP
sink/NPN
Type: pH
ORP
Mode:
Symmetric
Asymmetric
Mains Fcy: 50Hz
60Hz
9.9. Activating/deactivating the hold
function
The Hold mode is automatically deactivated when the trans-
mitter restarts after a power interruption, if the Hold mode
was activated at the moment of the power cut-off.
Calib System
English
Hold Hold:Disable
Hold:Enable
35