Section 3: Operating The Pump; Starting The Pump; Stopping The Pump; Operating The Pump At Preset Speeds - Pentair INTELLIFLO VSD series Bedienungsanleitung

11
This section describes how to operate the IntelliFlo
features.

Starting the pump

To start the pump
1. Be sure the pump is powered on and the green power LED is on.
2. Select one of the speed buttons, then press the Start button (LED on) to start the pump.

Stopping the pump

To stop the pump
• Press the Stop button to stop the pump.
Note: The pump can automatically restart if the communication cable is connected.
Servicing Equipment (Disconnect Power to Pump)
• When servicing equipment (filters, heaters, chlorinators etc.), disconnect the
communication cable, and switch OFF circuit breaker to remove power from the pump.
Operating the IntelliFlo Pump at Preset Speeds
The IntelliFlo
RPM. A Speed button is assigned to each of the preset speeds as shown.
To operate the pump at one of the four preset speeds
1. Be sure the pump is powered on and the green power LED is on.
2. Press the Speed button (1- 4) corresponding to the desired preset speed, and release
quickly. The LED above the Speed button will come on as shown.
3. Press the Start button. The pump will quickly ramp to the selected preset speed.
Adjusting the pump speed
1. While the pump is running, press the Up Arrow to increase speed setting.
Press the Down Arrow to decrease speed Setting.
2.
3. Press and hold down a Speed Button for three (3) seconds to save speed to the button or
press the Enter button to save the speed.
VSD pump is programmed with four default speeds of 750, 1500, 2350 and 3110
®
LED lit
Speed Speed
1 2
Operating the Pump
pump using the control panel buttons and menu
®
Speed Speed
3 4
Section 3