External Control; Features: Quick Clean - Pentair INTELLIFLO VSD series Bedienungsanleitung

20
Programming for Constant Run
When programming a schedule for a Speed, the Speed can not be programmed with the same start
and stop times. However, it will run without stopping if it is programmed with the Start time set
one minute after the stop time. Example: A single speed will run non stop if programmed with a
Start Time of 8:00 AM and a Stop time of 7:59 AM.

External Control

This function is for programming speeds that will run when the IntelliComm power center controller
sends it a command. For example, Terminal 3 and 4 in IntelliComm will correspond to External Control
Program #1. (5 and 6 to Ext Ctrl #2). Use the External Control feature to program the IntelliComm
power center.
To access the Ext. Ctrl. menu:
1. Check that the green power LED is on.
2. Press the Menu button. "Settings" is displayed.
3. Use the Up or Down arrow button to scroll to "Ext. Ctrl.".
5. Press the Select button. "Program 1" is displayed.
6. Press the Select button. "750 RPM' is displayed.
7. Press the Select button. The "RPM" number will highlight.
8. Press Up or Down arrow button to change the RPM setting.
9. Press the Enter button to save the setting. Note: To cancel any changes, press the Escape
button to exit without saving.
10. Press the Escape button.
11. Use the Up or Down arrow button to scroll to "Program 2".
12. Repeat Step 5 through 9 to set Program 2, 3, and 4.12 Programmable Speeds.

Features: Quick Clean

This feature can be used to ramp the pump up to a higher RPM for vacuuming, cleaning, adding
chemicals, after a storm for extra skimming capability. Press the Quick Clean button (LED on)
and then the Start/Stop button (LED on) to start the pump at preset RPM and duration of time.
When the Quick Clean cycle is over it will resume regular schedules, it will be in the "Running
Schedule" mode.