PeakTech 1145 Bedienungsanleitung Seite 70

6.2. Using the Single-function
To capture a single waveform or a noise effectively, do the following steps
1. Adjust the VOLTS/DIV and TIME/DIV to proper ranges.
2. Push the ACQUIRE button and choose Peak Detect On if you want to see the peak value or Peak Detect Off if not.
3. Push the TRIGGER MENU button and select the signal slope.
4. Adjust the trigger level by using the TRIGGER LEVEL knob.
5. Push the SINGLE button on the top of the panel or select single mode in the trigger mode menu. Then, you can
see the single ready condition on the top of the screen. "RUN" means ready condition, "STOP" means the end of
single capture.
If you want to set single ready condition again, only push the SINGLE button or the RUN/STOP button.
Use TIME/DIV switch to magnify a waveform. Move TIME/DIV
switch to lower time division and you will see a magnified
waveform.
If you want to have more magnified waveform. Move TIME/DIV
switch to the next lower time division.
-28-