Configuration And Set-Up - Telecom Behnke 5 Serie Anleitung

Instructions for Series 5 / 10
GB

Configuration and Set-up

Configuration and set-uP
4.
Configuration for your new device may be set
remotely using a telephone with DTMF dialling.
To enter set-up mode, you need to enter a four-
digit security code. The different settings are
changed via configuration step codes with an
individual code for each function to be set.
1 Start set-up mode
Remotely by using a telephone with DTMF
dialling:
▸
Call your Behnke Series 5/10 Intercom station
▸
The Behnke Series 5/10 Intercom station will
pick up the call and answer with a beep
▸
Press the * key within two
seconds after the beep (in case more than
two seconds elapse before the * key is
pressed, set-up mode may also be activated
by pressing the * key twice) [beep]
▸
Enter the security code (default: 0 0 0 0)
[beep] [beep]
2 Enter the configuration step code
▸
Enter the configuration step code (cf. table
page) [beep ] [beep]
▸
Enter the desired parameter and confirm
with the # key [beep] [beep] [beep]
48
The different configuration steps do not need
to follow a certain order. Entering incorrect
information in set-up mode will result in a
darker, slightly longer error tone. After the error
tone, you may continue set-up by entering the
next configuration step code. Set-up mode will
be automatically terminated after 30 seconds of
inactivity.
3 Terminate set-up mode
▸
Press the * key or no entry for 30 seconds.
www.behnke-online.com