Operation; Led Indicators; Alarm Output - Siemens pointek CLS100 Schnellstartanleitung

Operation

Start Up
After the CLS100 is properly mounted and wired, apply power to the unit. The green LED
lights to indicate the unit is powered and operational.

LED Indicators

Yellow = sensor status
Red = output status
Green = power

Alarm Output

Setpoint Adjustment
As a guide to adjusting the alarm set point for reliable and accurate detection of the
process material, we have classified the materials and applications into three cases.
Follow the setup procedure associated with the case outline describing your application.
Please note that sensitivity of the unit can be adjusted by the user as required.
7ML19985QJ82
• ON indicates contact with the process material (material capacitance is
greater than the set point).
• OFF indicates when the sensor is out of contact with the process
material (material capacitance is less than the set point).
• ON indicates the mA loop alarm and solid state switch contact status.
Alarm Output Status
Refer to
• ON indicates the CLS100 is properly powered.
20-turn trimpot
Pointek CLS100 – QUICK START MANUAL
on page 7.
Page EN-11