Oase Bitron 9C Gebrauchsanweisung Seite 13

GB Operating instructions
5. Installation
- You must read and follow the safety instructions before the installation!
- The Bitron 9C/11C is suitable for a pump capacity of up to 5,500 l/h. The water
flow-through on the UVC bulb should not exceed 1500l/h for the Bitron 9C,
and 1700 l/h for the Bitron 11C. See the bypass setting.
- Please select the filter system according to the following table (selection
criteria: Pond size and with/without fish stock).
Aquamax 2.000
Aquamax 3.500
Aquamax 5.500
Near natural garden ponds with plant zones and no fish stock.
Near nature garden ponds with plants and a fish stock of up to 1000
grams per 1000 liters.
Garden and koi ponds with a fish stock of 1000 grams to 3000 grams
per 1000 liters.
5.1 Setting up the Bitron
5.1.1 Single setup with hoses
- Anchor the Bitron horizontally on a suitable substrate with the feet down.
Mounting platform drill
diagram
- Use Ø 3.9 mm metal screws to mount the unit.
- The screw may be screwed into the casing feet a maximum of 22 mm.
- When using the Aquamax 2000, the bypass can be closed with the sealing
cap (1d). A second line should be attached for the bypass for Aquamax 3500
and 5500.
- Adjust the bypass according to 5.2 and close the hoses according to 5.3.
- Push the threaded collar (1a) over the stepped hose adapter (1b). Push the hose
up and secure with a hose clamp (one hose clamp in each of these sizes is
included: ¾", 1", 1¼" and 1½" for the water supply. Insert the flat gasket (1c) into
the threaded collar (1a) and screw it tightly onto the threaded duct.
1 x Bitron 9C/11C, 1 x Biotec 4
3,5 m³
5 m³
8 m³
2 m³ 1m³
2,5 m³ 1,5 m³
3,5 m³ 2 m³
150 mm
mm
GB
13