Connecting The Hoses; Filling The Pump; Checks Before Initional Operation; Switching On And Off - Parkside PGPS 1100 A1 Originalbetriebsanleitung

Connecting the hoses

- On the suction side, attach a
hose with backlow preventer
and install a preilter (available
from specialist retailers).
- On the suction side, do not use
any quick-action connection sys-
tems.
- Do not use the suction hose as a
pressure pipeline.
1. Remove the cover caps (1/3)
from the device.
2. Unless already mounted, screw
the pre-ilter with backlow pre-
venter (15) and pre-ilter connec-
tion (16) onto the suction hose
(14). All parts are marked
with a
3. First, screw the adapter piece
(11) with water inlet (2) onto the
device. Both pieces marked with
an .
A
4. Next, screw the suction hose
connection water inlet (13) with
the sealing ring (12) onto the
adapter piece (11). Both pieces
marked with an
ter inlet free from air.
5. Fit a pressure hose to the water
outlet (4) Fit the water outlet free
from air.
Air in the suction hose will stop the
garden pump from working properly.

Filling the pump

Fill up the garden pump every time before
you start using it. Caution: Avoid dry run-
ning of the pump! Danger of overheating!
Never touch an overheated pump! There is
a danger of burns!
.
B
. Fit the wa-
A
When switching on the pump, ensure that
the pump and suction hose are completely
illed with water in order to prevent the dry
running of the pump. Dry running dam-
ages the device.
1. Open the illing screw (
garden pump.
2. Fill with water to the ill point and
retighten the illing screw (
Checks before initional
operation
• Check that the electrical connec-
tion is 230 V~ / 50 Hz.
• Check the proper status of the elec-
trical plug socket and make sure
that the plug socket is suficiently
fused (at least 10 A).
• Make sure that moisture or water
never come in contact with the
mains connection. There is a risk
of electrocution.
• Control the suction hose. The end
of the suction hose must be placed
in water.
• Control the suction hose. The end
of the suction hose must be in out-
let position.
The device is not suitable to be con-
nected to a drinking water supply
system.

Switching ON and OFF

1. Connect the power cable (
power supply.
2. Switching On: On/Off Switch (
position "I" After a suction period the
pump begins the supply of water.
3. Switching Off: On/Off Switch (
In position "0"
GB IE
9) on the
9).
6) to the
5) In
5)
19