Toshiba MM-U056 Installationsanleitung Seite 6

Location Precautions
Avoid installing the indoor unit in the following locations:
!
Where there is danger of flammable gas leakages.
! Where there are high concentrations of oil.
Where the atmosphere contains an excess of salt (as in coastal areas).
!
The air conditioner is prone to failure when used under this condition unless special maintenance
is provided.
!
Where high concentrations of organic solvent are present.
GB
!
Where a machine that generates high frequencies is operated.
!
Where the unit will not be horizontal.
!
Where the ceiling height is more than 3m.
!
Where the floor/wall/ceiling structure is unable to support the weight of the unit.
!
Where it is not possible to fix the unit hangers, e.g. window glass.
Locate the unit so as to provide uniform circulation of chilled air.
If a good location is not possible, use a fan to circulate the air evenly throughout the room.
Choose the number of airflows that are required, depending on the shape of the room and the
location of the indoor unit.
3-way
3-way
! It is not possible to block the air flow from the longer sides of the unit (U112/U140).
The number of airflow directions cannot be adjusted after installation.
!
Insert insulation blocks, which are supplied as accessories,
!
at each side where the airflow is not required,
as shown in the diagram opposite.
I
NDOOR
— MM-C and MM-K Units only —
Avoid locating the unit as shown in the

Good location —
Evenly cooled
— MM-U Units only —
MM-U056/U080
3-way 3-way
2-way 2-way
U L
NIT OCATION
✗
-marked figures below:
✗
Bad location —
Oblique-line
area not well
cooled \\\\\
MM-U112/U140
3-way 3-way
~ 6 ~
✗
Bad location —
Oblique-line
area not well
cooled /////
2-way
Insulation
Block