Waeco MagicWatch MWE 150 Montage- Und Bedienungsanleitung Seite 32

MWE-150-2.book Seite 32 Freitag, 3. Februar 2006 4:52 16
Installing MagicWatch
The assembly procedure is as follows:
➤ Choose an installation location on the bumper which is as perpendicular
to the road surface as possible (a, page 6).
The plugs must be connected with the correct polarity. A blocking pin pre-
vents reverse polarity (b A, page 6).
Make sure the locking pin catches (b A, page 6). Only then is trouble-
free operation guaranteed.
To release the connection press the holder and pull the plug and socket
apart (b B, page 6).
If the sensor cable is not long enough, you can order one-metre extension
cables (MWCS-1) as accessories.
Caution!
Before making any drill holes, ensure that no electrical cables or
other parts of the vehicle can be damaged by drilling, sawing and
filing.
➤ For each sensor, drill a hole with a diameter of 22 mm in the bumper.
➤ For a more accurate fit, slant the drill downwards slightly when drilling the
hole on the inside of the bumper. The sensor cover can now be easily in-
serted at a downward angle.
➤ Guide the cables of the sensors through the corresponding hole.
➤ Insert each sensor into the corresponding drill hole until it latches into
place.
32
MagicWatch MWE150