4.2.2 Application
CAUTION
Use on skin sensitive to heat
Skin irritation due to overheating
►
Do not use the product in case of a known heat allergy.
►
When in doubt, do not continue to use the product if skin irritation occurs.
Inform the patient.
►
CAUTION
Incorrect or excessively tight application
Risk of local pressure and constriction of blood vessels and nerves due to improper or excess
ively tight application
►
Ensure that the orthosis is applied properly and fits correctly.
Inform the patient.
►
8356 Genu Direxa
>
Open all hook-and-loop closures on the orthosis.
>
The patient is sitting on the front edge of a chair.
1) Hold the orthosis on both sides with the donning loops and pull it over the knee until the
patella cutout is centred on the patella (see Fig. 1 and see Fig. 2).
2) Close the hook-and-loop straps first below and then above the patella (see Fig. 2 and see
Fig. 3).
8353 Genu Direxa wraparound
>
Open all hook-and-loop closures on the orthosis.
>
The patient is sitting on the front edge of a chair.
1) Wrap the orthosis around the knee from behind (see Fig. 4).
2) Centre the patella cutout over the patella.
3) Fasten the hook-and-loop closure below the patella cutout while applying tension. Make sure
that the hook-and-loop sections are placed over one another (see Fig. 5).
4) Fasten the hook-and-loop closure above the patella cutout while applying tension. Make sure
that the hook-and-loop sections are placed over one another (see Fig. 5).
5) Fasten the straps first below and then above the patella. Make sure that the hook-and-loop
sections are placed over one another (see Fig. 6 and see Fig. 7).
4.3 Cleaning
NOTICE
Use of improper cleaning agents
Damage to the product due to use of improper cleaning agents
►
Only clean the product with the approved cleaning agents.
1) Pull the black strap upwards to remove the bracket over the joint bar (see Fig. 8).
2) Pull the joint bars out of the orthosis (see Fig. 9).
3) Fasten all hook-and-loop closures.
4) Recommendation: Use a laundry bag or net.
5) Wash the orthosis in warm water at 40 °C with standard mild detergent. Do not use fabric
softener. Rinse well.
6) Allow to air dry. Do not expose to direct heat sources (e.g. sunlight, stove or radiator).
7) Reinsert the joint bars.
INFORMATION: The labelling on the joint bars must be visible from the outside.
Ottobock | 11