Packaging; Spare Parts - Abicor Binzel iSTM A360 Originalbetriebsanleitung

12 Disposal
12 Disposal
12.1 Materials
12.2 Consumables

12.3 Packaging

13 Spare parts

EN - 22
For the disposal observe the local regulations, laws, provisions, standards and
guidelines. For the iSTM to be properly disposed of, it first must be dismounted.
 11 Dismounting on page EN-21
This product consists for the most part of plastics, steel and non-ferrous metals.
Steel and non-ferrous metals can be molten in steel and iron works and are thus
almost infinitely recyclable. The plastic materials used are marked in
preparation for sorting and separation of the materials for later recycling.
Oil, grease and cleaning agents must not contaminate the ground or enter
sewage systems. These materials must be stored, transported and disposed of
in suitable containers. Observe the relevant local regulations and disposal
instructions of the safety data sheets specified by the manufacturer of the
consumables. Contaminated cleaning tools (brushes, rags, etc.) must also be
disposed of in accordance with the information provided by the manufacturer
of the consumables.
ABICOR BINZEL has reduced the packaging for shipping to a minimum.
Packaging materials are always selected with regard to their possible recycling
ability.
 appendix
iSTM