Fitting The Steering Wheel - Sabo 102-17 HF Betriebsanleitung

10 UNPACKING AND ASSEMBLY
EN

3.2 FITTING THE STEERING WHEEL

Put the machine on a flat surface and
straighten up the front wheels.
2
Fit the steering wheel (1) onto the protruding
1
shaft (2) with the spokes directed towards
the seat.
Line up the hole in the steering wheel hub
3
with the hole in the shaft and insert the pin
supplied (3) using a hammer, ensuring that
the end comes completely through to the opposite side.
NOTE
To avoid damaging the steering wheel, use a punch or a screw-
driver of the same size as the pin when hammering it in the last part.
3.3 FITTING THE SEAT
Raise the adjustment lever (3) and fit the
4
seat (1) in the slide (2), introducing it from
the steering wheel's side, till the seat
engages in one of the 6 positions.
At this point the seat is engaged and cannot
be completely removed unless the lever (4)
2 1 3
is pressed, freeing it from its retainer.
3.4 ASSEMBLY AND CONNECTING THE BATTERY
Position the battery (1) in its compartment
under the seat.
3
1
Connect the red cable (2) to the positive
terminal (+) and the black cable (3) to the
negative terminal (–) using the supplied
screws and following the illustrated
sequence.
Fit the spring (4) to hold the battery in
place and make sure all the wires are in
front of the battery so that they don't get
4
2
caught in the spring (4).