Manually Connecting The Subwoofer If Automatic Connection Fails - Samsung harman/kardon HW-N850 Benutzerhandbuch

Blinking
Red On
Red and
Blinking
blue

Manually connecting the Subwoofer if automatic connection fails

Before performing the manual connection procedure below:
• Check whether the power cables for the Soundbar and subwoofer are connected properly.
• Make sure that the Soundbar is turned on.
1. Press and hold ID SET on the rear of the subwoofer for at least 5 seconds.
• The red indicator on the rear of the subwoofer turns off and the blue indicator blinks.
2. Press and hold the Up button on the remote control for at least 5 seconds.
• The ID SET message appears on the display of the Soundbar for a moment, and then it
disappears.
• The Soundbar will automatically power on when ID SET is complete.
Standby (with the Soundbar
main unit turned off)
Connection failed
Standby (with the Soundbar
main unit turned off)
Connection failed
Malfunction
Check the power supply to the Soundbar
main unit.
Connect again. (Refer to the instructions on
manual connection on page 7.)
Check the power supply to the Soundbar
main unit.
Connect again. (Refer to the instructions on
manual connection on page 7.)
See the contact information for the
Samsung Service Centre in this manual.
ENG - 7