Manually Connecting The Subwoofer If Automatic Connection Fails - Samsung HW-M450 Bedienungsanleitung

Manually connecting the subwoofer if automatic connection fails

Check before performing the manual connection
• Check whether the power cables for the Soundbar and subwoofer are connected properly.
• Make sure that the Soundbar is turned on.
1. Press and hold ID SET on the rear of the subwoofer for at least 5 seconds.
The red indicator on the rear of the subwoofer turns off and the blue indicator blinks.
2. Turn off the Soundbar.
3. Press and hold the VOL button on the remote control for at least 5 seconds with the Soundbar
turned off (OFF).
4. The ID SET message appears on the display of the Soundbar for 1.3 seconds, and then disappear.
5 Sec
5. When the blue indicator on the subwoofer blinks, turn on the Soundbar's power by pressing
(Power) button on the right side of the main unit or on the remote control.
6. When the connection is successfully established, the blue indicator on the rear of the subwoofer
stops blinking and glows continuously.
• If the connection process fails, the blue indicator will flash continuously. Go to Step 1 and start again.
NOTES
• Do not connect the power cord of this product or your TV to a wall outlet until all connections
between components are complete.
• Before moving or installing this product, be sure to turn off the power and disconnect the power
cord.
Rear of Subwoofer
ID SET
ENG - 7
5 Sec