Siemens SIMOVERT MASTERDRIVES Betriebsanleitung Seite 174

Installation
Removing the
option card holder
Installing the
optional board
NOTICE
Slot A
Slot B
Slot C
Mounting the option
card holder
5-6
Remove the fixing screws of the option card holder from the pins and lift
the option card holder from the device.
Optional boards can only be inserted in slot A and slot B. Slot C of the
unit is permanently pre-assigned for the terminal module EBV.
Push the optional board from behind into the opening on the front cover
( ) until the position of the 64-pole system connector on the main
board corresponds with the position of the socket.
Insert the optional board from the right onto the 64-pole system
connector on the main board (
Screw the optional board tight at the fastening points in the front section
of the optional board (
Fig. 5-6 Installing the optional board
Place the option card holder horizontally on the rear edge of all fitted
option cards and tighten the previously removed screws at the fixing
points.
). The view shows the installed state.
).
Slot A
Slot B
Slot C
6SE7087-6JP60
Operating Instructions
02.2008
Siemens AG
SIMOVERT MASTERDRIVES