Emptying The Coffee Grounds Container; Cleaning The Grinder - AEG Electrolux CF 2 Serie Gebrauchsanweisung

g
height adjuster right down, and off the
bottom. To do this, gently raise the
inside catch. Use warm water to clean
any coffee residues from both parts.
Reassemble the two parts. To do this,
gently pull up the catch. Check the
ease of movement of the height
adjuster. Refit the service cover and
push the grounds container back in
place.
13.2 Emptying the Coffee Grounds
Container
At regular intervals, after every 16 cof-
fee brews, the "Empty grounds con-
tainer" indicator (Fig. 3, j)
that the container has to be emptied
and cleaned.
0 When the coffee machine is in daily
use, empty the container daily. The
indicator flashes for around 1 minute
each time the machine is switched off,
as a reminder to do this.
Always empty the grounds container
3
with the coffee machine switched on,
otherwise the coffee machine does not
register that the container has been
emptied.

13.3 Cleaning the Grinder

Use the supplied brush to remove
ground coffee residues.
1 Note! Never put water in the grinder.
This would damage the grinder.
0 Press the "On/Off" key (Fig. 3, h)
switch off the coffee machine. Unplug
from the mains socket.
0 Turn the bean container so that the
mark is at the "UnlockContainer" posi-
tion and remove the container
(Fig. 23).
0 Remove any remaining coffee beans
(you could use the vacuum cleaner
with the hose or crevice tool attach-
ment for this).
3 If a foreign body is impossible to
remove, take off the grinding ring.
38
0 To do this, proceed as follows (Fig. 24):
1. Push the Release catch for removing
grinding ring (Fig. 2, T) forward toward
the centre of the grinder.
2. Keep it in this position and turn the
Lever for setting grinding texture (Fig.
2, U) approximately one full turn
clockwise until it comes up against the
stop.
You can continue to turn the Lever for
3
setting grinding texture (Fig. 2, U) only
if the Release catch for removing
grinding ring (Fig. 2, T) is pressed.
0 Now release the grinding ring (Fig. 25)
and remove the foreign body or bodies.
signals
Caution! Risk of injury from the spin-
1
ning grinder. Never switch the coffee
machine on, when you are working on
the grinder. This can lead to severe
injuries. Before starting work, ensure
that the machine is unplugged from
the mains socket.
3 When refitting the grinding ring,
ensure that both catches on the grind-
ing ring holder engage in the corre-
sponding slots (Fig. 25).
Failure to do this can lead to damage
to the grinder.
0 Turn the Lever for setting grinding tex-
ture (Fig. 2, U) approximately one full
turn anticlockwise until it comes up
against the stop.
0 Set the bean container in place at the
to
"UnlockContainer" position
turn it back to the "Coffee Beans" posi-
tion
0 Add a small quantity of coffee beans,
and test the proper operation of the
grinder by making a cup of coffee. The
first time the grinder is used, or after
cleaning, less ground coffee will enter
the coffee-making unit, because the
channel first has to be filled. This can
influence the first cup of coffee.
.
, and