Starting And Stopping A Camera Cycle; Displaying Alarm Messages - Geutebruck Pilot Bedienungsanleitung

Starting and stopping a camera cycle

With the Pilot, you can start and stop the execution of camera cycles on specific
monitors. The camera cycles themselves are configured with the program GeViSoft.
1.
2.
The sequence of the camera cycles must first be configured using GeViSoft software
Note
or a suitable interface. The actual execution of the cycle is controlled by GeViSoft
and is performed by an external device such as a control computer. GeViSoft acti-
vates the corresponding cameras at the right times on the respective monitors or
GSCView windows.
Alarm processing
The alarm management system of GSCView determines how and in which order
notification is made in case of an incident.
Once on an alarm event occurs on a monitor or viewer, whose controller is assigned
to the Pilot, this alarm is then also issued on the Pilot: The alarm sounds and the
alarm text is displayed.
If an alarm occurs, you are guided directly by the automatic alarm display and are
not distracted by complicated operating procedures.

Displaying alarm messages

Once an alarm occurs, the alarm is displayed with the color of its priority, start time
and configured alarm text. If there is no configured text, only the triggered event is
listed. At the same time, an alarm signal sounds, if set in the Pilot Editor.
1.
2.
3.
V 1.3
Select the appropriate camera cycle number with the numeric keypad and then
press Start Camera Cycle in Menu 1 to start the camera cycle on the currently
active monitor.
Use the Stop Camera Cycle button to stop the cycle.
Acknowledge the alarm message by pressing Alarm Management.
The event list appears.
Process the alarm messages in the event list in sequence according to the in-
structions.
To close the event list, press Alarm Management again.
Working with the Pilot
33