Troubleshooting - EMAK Starjet AJ102 Bedienungsanleitung

Symbol
6.4
Apply grease to:
angle joints of the drive connecting rods - remove and lubricate

brake rod bolt - lubricate the rod near the bolt hole

bolt to the mowing mechanism lift rod - lubricate the rod in the area of the bolt hole

angle joints of the steering connecting rods - remove and lubricate

angle joints of the wheel pins - remove and lubricate

front wheel bearings

wheel pins that go through the axle

centre rotary pin of the front axle - through the grease nipple

steering wheel shaft bearing - lubricate

toothed steering segment and eccentric - lubricate

half-axles of the rear wheels

spigots of the wheels of the front axle for the front wheel (machine AJ102 4x4)

rear half-axles for the rear wheel (machine AJ102 4x4)

Use oil to lubricate the rotating points:
axle lock pedal

brake pedal


7. TROUBLESHOOTING

Never perform a service operation if you do not have the appropriate qualifications and equipment. The
operations below can be performed by the user. Service operations other than those shown here will
void the warranty when performed by the user. The manufacturer is not liable for damages resulting
from the user's poor execution of prohibited service operations.
Problem
The machine cuts
unevenly
Explanation
Grease
SAE 30 oil
Interval in
hours
 Remove clogged clippings from the underside of the mowing mechanism.
 Make sure the blades are sharp and not deformed.
 Check the blade tightness.
 Check the mowing mechanism's height adjustment. (
 Check the tension of the belts (
 Check the blade shaft. If it is damaged or overly worn, replace it.
Solution
6.3.8 and 6.3.9). If necessary, adjust the tension.
57
6.3.7). If it is not correct, readjust it.