LUCCI AIRFUSION QUEST II Installationsanleitung Seite 7

LIGHT KIT Installation (Light kit - optional)
Note: Light kit must be installed by a Licensed Electrician.
NOTE: The light kit is available for selected ceiling fan models and as an optional light kit.
1. Remove the decorative cover from the shaft.
2. Pull the L and N wire out from the shaft.
3. Insert wires through the light connector (1).
4. Tighten the light connector into the shaft firmly with a spanner.
5. Secure the light base (2) to copper connector (1) by tightening the screw nut (3).
6. Take off the wire protective cover (5) from terminal block (4) by loosening the screw nut (6).
7. Connect the L and N wire from fan to the terminal block (4) on the light base according to the label.
8. Re-install the wire protective cover.
9. Install the globes (not included).
10. Lift and attach the glass (7) to the lamp base and secure it by using three spring clips (8).
Fig. 6
7
Fig. 7