Specifications - Makita DP2010 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Switch trigger
1-2. Lock button
2-1. Speed control screw
2-2. Higher
2-3. Lower

SPECIFICATIONS

Capacities
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for drilling in wood, metal and
plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
Explanation of general view
3-1. Reversing switch
4-1. Tighten
4-2. Chuck key
5-1. Sleeve
5-2. Ring
Model
Steel
Wood
-1
)
Overall length
Net weight
Safety class
noise level determined
) : 77 dB(A)
pA
value (tri-axial vector
2
) : 4.0 m/s
h,D
2
DP2010
6.5 mm
15 mm
0 - 4,200
209 mm
1.0 kg
ENE032-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
ENF002-2
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
ENG905-1
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
High Speed Drill
ENG900-1
Model No./ Type: DP2010, DP2011
are of series production and
sum)
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following
standards or standardised documents:
EN60745
The technical documentation is kept by:
ENG901-1
Makita International Europe Ltd.
Technical Department,
Michigan Drive, Tongwell,
Milton Keynes, Bucks MK15 8JD, England
3
6-1. Depth gauge
6-2. Washer
6-3. Clamp screw
/II
Corporation as
DP2011
6.5 mm
15 mm
0 - 4,200
222 mm
1.1 kg
/II
ENH101-16
the responsible