Connecting The Usb Device To The Client - SEH myUTN-50a Schnellinstallationsanleitung

Connecting the USB Device to the Client

To use a USB device, a connection is established between the client and the USB
port of the UTN server to which the USB device is connected.
Make sure that:
- All provisions (driver installation, etc.) necessary to operate the USB device
locally (i.e. connected directly to the client) have been met on the client.
Ideally, the USB device has been connected and operated on the client locally
according to the instructions of the manufacturer.
- The USB port is not connected to another client. A USB device that was made
available by the UTN server can only be used by one network participant at a
time.
Proceed as follows:
1. Select the port from the selection list.
2. Select Port – Activate from the menu bar.
The connection will be established.
Close the connection to the USB port when the connected USB device is no
longer needed. Select Port – Deactivate from the menu bar.
Quick Installation Guide [en] 13