Specifications; Additional Safety Rules - Makita HK0500 Betriebsanleitung

ENGLISH
Bit
Chuck cover
Change ring

SPECIFICATIONS

Model
Blows per minute ...........................2,000 – 3,500
Overall length...........................................468 mm
Net weight ...................................................3.1 kg
• Due to the continuing program of research and
development, the specifications herein are sub-
ject to change without prior notice.
• Note: Specifications may differ from country to
country.
Power supply
The machine should be connected only to a
power supply of the same voltage as indicated on
the nameplate, and can only be operated on sin-
gle-phase AC supply. They are double-insulated
in accordance with European Standard and can,
therefore, also be used from sockets without
earth wire.
Safety hints
For your own safety, please refer to enclosed
safety instructions.

ADDITIONAL SAFETY RULES

1. Wear a hard hat (safety helmet), safety
glasses and/or face shield. It is also highly
recommended that you wear a dust mask,
ear protectors and thickly padded gloves.
2. Be sure the bit is secured in place before
operation.
3. Under normal operation, the machine is
designed to produce vibration. The screws
can come loose easily, causing a break-
down or accident. Check tightness of
screws carefully before operation.
4. In cold weather or when the machine has
not been used for a long time, let the
machine warm up for several minutes by
operating it under no load. This will loosen
up the lubrica tion. Without proper warm-
up, hammering operation is difficult.
Explanation of general view
Switch trigger
Adjusting dial
5. Always be sure you have a firm footing. Be
sure no one is below when using the
HK0500
machine in high locations.
6. Hold the machine firmly with both hands.
7. Keep hands away from moving parts.
8. Do not leave the machine running. Operate
the machine only when hand-held.
9. Do not point the machine at any one in the
area when operating. The bit could fly out
and injure someone seriously.
10.When chipping into walls, floors or wher-
ever "live" electrical wires may be encoun-
tered, DO NOT TOUCH ANY METAL PARTS
OF THE MACHINE!
Hold the machine by the insulated grasp-
ing surfaces to prevent electric shock if
you chip into a "live" wire.
11.Do not touch the bit or parts close to the
bit immediately after operation; they may
be extremely hot and could burn your skin.
SAVE THESE INSTRUCTIONS.
OPERATING INSTRUCTIONS
Installing or removing bit
Important:
Always be sure that the machine is switched off
and unplugged before installing or removing the
bit.
Clean the bit shank before installing the bit. Insert
the bit into the machine.Turn the bit and push it in
until it engages. (Fig. 1)
If the bit cannot be pushed in, remove the bit. Pull
the chuck cover down a couple of times. Then
insert the bit again. Turn the bit and push it in until
it engages. (Fig. 2)
After installing, always make sure that the bit is
securely held in place by trying to pull it out. To
remove the bit, pull the chuck cover down all the
way and pull the bit out. (Fig. 3)
Tile
Scaling chisel
5