Safety Information - EdilKamin BIJOUX Installations-, Betriebs- Und Wartungsanleitung

THE BOILER-STOVE MUST NEVER BE MADE TO OPE-
RATE WITHOUT WATER IN THE SYSTEM.
IT CAN BE DAMAGED IF IT IS IGNITED WITH NO WA-
TER IN THE SYSTEM.
MUST BE MADE WITH A PRESSURE OF ABOUT 1.5 BAR.
• The boiler-stove is designed to heat water by means of
automatic combustion of pellets in the hearth.
• The only risks that may derive from using the pertain to non-
compliance with the installation regulations, direct contact with
live electrical parts (internal), contact with the re or hot parts,
or foreign substances being put into the boiler.
• Should components fail, the boiler-stove is equipped with
safety devices to guarantee its automatic shutdown.
These are activated without any intervention required.
• In order to function correctly, the boiler must be installed in
accordance with the instructions given herein and the door
must not be opened during operation: combustion is fully
automatic and requires no intervention.
• Only use wood pellets as fuel.
• Under no circumstances should any foreign substances be put
into the hearth or the hopper.
• Do not use ammable products to clean the smoke channel
(the ue section connecting the boiler-stove smoke outlet to the
chimney ue).
• Do not clean when hot.
• Hearth and hopper components must only be cleaned with a
vacuum cleaner.
• The glass can be cleaned when COLD with a suitable product
and a cloth.
If a re begins on the thermo stove, in the smoke duct or the ue pipe, proceed as follows:
- Disconnect the power supply
- Use a carbon dioxide (CO
- Call the re brigade
DO NOT ATTEMPT TO PUT THE FIRE OUT WITH WATER!
After the event, have the appliance checked by an authorised Service Centre and have an authorised technician check the ue.

SAFETY INFORMATION

IMPORTANT!!!
2
) extinguisher
• Make sure the boiler-stove is installed and ignited the rst
time by Edilkamin-quali ed CAT personnel (technical assistan-
ce centre) in accordance with the instructions provided here
within; this is an essential requirement for the validation of the
guarantee.
• Whilst the boiler-stove is in operation, the exhaust pipes and door
become very hot (do not touch without using the right gloves).
• Do not place anything, which is not heat resistant near the
boiler-stove.
• NEVER use liquid fuel to ignite the boiler-stove or rekindle
the embers.
• Do not obstruct the ventilation apertures in the room where the
boiler-stove is installed, nor the air inlets of the boiler-stove itself.
Do not wet the boiler-stove and do not go near electrical parts
with wet hands.
• Do not use reducers on the smoke exhaust pipes.
• The boiler- stove must be installed in a room that is suitable
for re prevention and equipped with all that is required (power
and air supply and outlets) for the boiler-stove to function
correctly and safely.
• The boiler-stove must be kept in a room where the temperatu-
re is above 0 °C.
• Use appropriate anti-freeze additives for the water of the
system.
• In the event that the water used for lling and toping up
has a hardness greater than 35° F, use a water softener. For
suggestions please refer to regulation UNI 8065-1989 (Water
Treatment In Heating Systems For Civil Use).
• SHOULD IGNITION FAIL, DO NOT RE-IGNITE
UNTIL YOU HAVE EMPTIED THE COMBUSTION
CHAMBER.
attention: the pellet emptied from the combustion chamber
must not be deposited inside the hopper.
- 31
-