Futurelight MH-420 Bedienungsanleitung Seite 60

- Music control
This function activates the music control, in order to run the programs according to the music in Stand Alone
Mode. Press the Up/Down Buttons to select „ON" or „OFF". Press the Enter Button to confirm, or the Mode
Button to cancel.
- Playback preset
This function allows you to select the the program which will be played in the stand-alone mode after
switching the fixture On.Use the [Up] and [Down] buttons to select desired program ("tESt"- bilt-in program)
or "OFF" if you don't want trigger any program after switching the fixture On and press [Enter] to confirm or
[Mode] to cancel and return to the menu.Selected program will be played continuously in a loop as long as it
appears on the display.
This option should be set "OFF" for all slaves in the master/slave chain by reason of the right program starts.
For example: You have selected program "PrG.3" in this menu and:
- this fixture is set as a single fixture (master/slave or controller operating)- the fixture will run its program
"PrG.3".
- this fixture is set as a master in a data chain- the fixture will run its program "PrG.3".
- this fixture is set as a slave in a data chain- the fixture will run its program according to the master(if the
master runs its own program "PrG.1", the slave will run its own program "PrG.1"also).
Note:If the fixture operates in the controller mode ( DMX controller is connected) and any program from this
menu is selected, in this case the fixture will not respond to the DMX controller after switching On and will
play selected program.
Playing program
-
This function allows you to run a built-in program "tESt" and the 3 freely-programmable programs "PrG.1,
PrG.2, PrG.3". Press [Up] or [Down] buttons to select the desired program and press [Enter] to run the
program which will be played continuously in a loop.
If you want to pause the runnnig program in the required position, press the [Enter]-
button(messages"PAUS"/"program No." flashes).To continue the program running, press the [Enter]-button
again.
Note: If the fixture operates in the controller mode (DMX controller is connected) and any program from this
function is selected in this case the fixture will not respond to the DMX controller and will play selected
program.
You can't play programs on the slave fixtures from their control panels if the master fixture is switched On
and connected to the slaves (playing is forced by the master).
Editing program
-
This menu item allows you to select a program to edit or create.The MH-240 has one built-in program
("tESt") and the 3 free programs,each up to 99 steps.Each program step has a dynamic part(fade time) and
static part(step time).
Fade time-the time,during which effects move to the programmed position.
Step time-the time,during which effects last in the current step.
If the fixture is set as a master, then you may edit any program in the slaves.You can't edit programs on the
slave fixtures from their control panels if the master fixture is switched on and connected to the slaves
(editing is possible by the master control panel only).
Procedure:
1. Press [Up] or [Down]-button to select the program you want to edit ("PrG.1" - "PrG.3") and press [Enter].
2. Press [Up] or [Down]-button to select the desired fixture ("MASt." - "SLA.9") and press [Enter]-button.
3. Press [Up] or [Down]-button to select the desired program step ("St.01" - "St.99") and press [Enter]-
button.
4 Press [Up] or [Down]-button to select the desired item and press [Enter]-button.Now you can edit by [Up]
or [Down] buttons the DMX value for selected item:
60