Hilti DD 150-U Bedienungsanleitung Seite 41

Ø core bits (stand- With water
guided drilling, collection sys-
wet) tem
Without water
collection sys-
tem
Ø core bits (hand- Without water
held drilling, wet) collection sys-
tem
Ø core bits (hand- With dust re-
held drilling, dry, moval system
HDMU)
Ø core bits (hand- With dust re-
held drilling, dry, moval system
PCM)
4.6 Use of the machine with various items of equipment
Hand-held/ Additional systems
Mounted on the
drill stand
hand-held/dry With dust removal system
hand-held/wet Without water collection system
hand-held/wet With water collection system
on drill stand/wet Without water collection system
on drill stand/wet With water collection system
4.7 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions have been measured in accordance with
a standardized test and may be used to compare one power tool with another. They may be used for a
preliminary assessment of exposure.
The data given represents the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools or is poorly maintained, the data may vary. This may
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the power tool is switched
off, or when it is running but not actually being used for a job. This may significantly reduce exposure over
the total working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: Maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise emission values
Sound (power) level (L
Uncertainty for the sound power level (K
Sound pressure level (L
Uncertainty for the sound pressure level (K
Total vibration
Drilling in concrete (wet) (a
Uncertainty (K)
Drilling with HDMU core bit in sand-lime block (dry) (a
*434949*
Printed: 05.02.2019 | Doc-Nr: PUB / 5069546 / 000 / 06
1st gear
102 mm ... 162 mm 28 mm ... 87 mm
102 mm ... 162 mm 28 mm ... 87 mm
121 mm ... 131 mm 41 mm ... 111 mm
122 mm ... 162 mm 67 mm ... 112 mm
52 mm ... 162 mm
)
WA
)
WA
)
pA
)
pA
)
h, DD
434949
2nd gear
•/•
Core bit diameter
37 mm ... 162 mm
8 mm ... 132 mm
8 mm ... 62 mm
12 mm ... 162 mm
12 mm ... 162 mm
Hand-held use
98 dB(A)
3 dB(A)
87 dB(A)
3 dB(A)
Hand-held use
7 m/s²
1.5 m/s²
) 6.5 m/s²
h, DD
3rd gear
12 mm ... 25 mm
12 mm ... 25 mm
8 mm ... 36 mm
•/•
•/•
Drilling direction
All directions
Not upwards
All directions
Not upwards
All directions
Mounted on the
drill stand
106 dB(A)
3 dB(A)
93 dB(A)
3 dB(A)
Mounted on the
drill stand
3.5 m/s²
1.5 m/s²
•/•
English 33