Getting Started - REVELL Control CHINOOK Bedienungsanleitung

1. GETTING STARTED:

Carefully connect the two parts of the fl ight cable on the helicopter. Turn the helicopter's ON/OFF switch to "ON". Place the
helicopter on the fl oor at a distance of 1-2 metres with the tail pointing towards you. Before you start, make sure that the
throttle stick (on the left of the controller) is in the down position to prevent the helicopter from taking off unexpectedly.
Move the controller's ON/OFF switch to "ON". To start the helicopter, slowly move the throttle stick upwards and set the
trim dial to the lowest position.
2. TRIMMING THE CONTROLLER:
Taking time to adjust the trimming will ensure that the helicopter fl ies smoothly. It is easy to do, but does require a little patience and a light touch.
Please follow these instructions carefully: Slowly move the throttle stick up to raise the helicopter to a height of about 0.5 metres to 1 metre.
If the helicopter spirals
right or keeps turning slowly
to the right... e righ
If the helicopter spirals right or keeps turning slowly to the right, turn the left and right trim dial
anti-clockwise until the helicopter stops turning.
Fine tuning:
If the helicopter continues to drift to one side when fl ying, try to correct this by moving the roll trim dial in the opposite direction to the way the helicopter is drifting.
Spirals right or
keeps turning right
If the helicopter moves forwards independently, turn the forward/backward trim dial clockwise
until it no longer moves forwards.
Fine tuning:
If the helicopter continues to drift forwards or backwards when fl ying, try to correct this by moving the pitch trim dial in the opposite direction to the way the helicopter is drifting.
3. FLIGHT CONTROL:
To take off or to make the helicopter fl y higher, carefully push the throttle stick upward.
8
To move forward, carefully push the direction stick forward.
Chinook_Anleitung_03.indd 8 Chinook_Anleitung_03.indd 8
Flying the Helicopter
If the helicopter spirals
left or keeps turning slowly
to the left... he lef
If the helicopter spirals left or keeps turning slowly to the left, turn the left and right trim dial ral
clockwise until the helicopter stops turning.
Spirals left or
keeps turning left
If the helicopter moves backwards independently, turn the forward/backward trim dial anti-clockwise
until it no longer moves backwards.
To land or to make the helicopter fl y lower, simply lower the throttle stick. The throttle stick
only needs to be moved very slightly to ensure smooth fl ying.
To move backwards, carefully pull the direction stick back.
Distance 2 m
13.05.2009 15:10:38 Uhr 13.05.2009 15:10:38 Uhr