Leister VARIANT T1 Bedienungsanleitung Seite 27

Info Icons
The following icons are shown on the display for information.
Welding nozzle cooling
down
Indicates that the temperature is rising
Indicates that the temperature is falling
Active Icons
The following icons are shown on the display and activated by pressing the e-Drive
Switch on heating and blower
(if blower not yet running)
Stop the drive
Start the drive
Automatic cooling down
(heating off , blower on)
Up in the structure
(back to the previous program)
Enter, confi rm
Info Icons
Active Icons
Quick Info
How do I start the hot air welding machine VARIANT T1?
1. Establish mains connection to the electrical mains
2. Main switch (3) ON
3. Press Drive button
4. Press Heating button
5. Press Blower button
6. Press e-Drive Heating up time approx. 1–2 minutes
7. Carry out a test weld according to the welding instructions of the
material manufacturer and national standards or directives.
Check test weld.
8. Welding
How do I switch off the hot air welding machine VARIANT T1?
1. Press e-Drive (Fig. 1).
2. Press «Cool down OK» e-Drive
Blower switches off automatically.
3. After welding nozzle (9) has cooled down, main switch (3) OFF
Device in Standby mode,
device is switched off
after a time
ON
and allow to cool approx. 4 minutes (Fig. 2).
Select profi le
Save changed name
Change profi le name
To next screen
To previous screen
Reset daily distance to zero
Turn e-Drive
Turn e-Drive
Turn e-Drive
OFF
Contact authorised
service centre
Progress bar
.
(Fig. 1) (Fig. 2)
27