Trouble Shooting - Schwaiger DSR 5108 T Bedienungsanleitung

TROUBLE SHOOTING

TROUBLE SHOOTING
Problem
The display on the front
panel does not light up.
No sound or picture, but the
front panel shows red light.
No sound or picture.
Bad picture / blocking
error.
The picture is not
displayed on the screen,
when switching on.
There is interference on
your terrestrial program
or video signal.
The RCU is not working.
Note : If you have tried all of the actions suggested above, without solving the
problem, please contact your dealer or a customer service adviser.
24
Possible causes
Main cable is not connected.
The receiver is in standby mode.
No signal or weak signal.
Signal is too strong.
Antenna noise factor too high.
The antenna is faulty.
The system is connected by RF
leads.
The system is connected by RF
leads and the output program of the
receiver interferes with an existing
terrestrial programs or Video signal.
Battery exhausted.
RCU is incorrectly aimed.
What to do
Check that the main cable is plugged into
the power socket.
Press the standby button.
Check the cable connections, antenna
and other equipment connected between
the antenna and the receiver.
Connect a signal attenuator to the
antenna input.
Change to an antenna with lower noise
factor.
Change the antenna.
Check the UHF channel fixed in your
system and tune the UHF channel
properly.
Change the receiver output program to
a more suitable program, or connect the
system by SCART leads.
Change the batteries.
Aim RCU at the receiver , or check that
nothing blocks the front panel.
TROUBLE SHOOTING