Interrupting Operation; Switching Off The Appliance - Kärcher HD 1000 Si Handbuch

GB
5.3 Adjusting Operating Pressure and
Flow Rate
·
You can adjust the operating pressure and
flow rate with the hand wheel on the hand
spray gun.
5.4 Operation with Cleaning Agent
·
Fill the cleaning agent tank.
·
Adjust the cleaning-agent metering valve to
the desired concentration.
·
For the sake of the environment, we
recommend that you use cleaning agent
sparingly. Observe the recommended dosage
on the container label of the cleaning agent.
·
We offer you an individual range of cleaning-
agents and care products, which guarantee
trouble-free work. Please obtain advice or
order our catalogue or cleaning-agent
information sheets.
Only those cleaning agents which have been
approved by the appliance manufacturer may
be used.
Unsuitable cleaning agents can damage the
appliance and the object to be cleaned.
·
We recommend the following cleaning
methods
Step 1: To loosen dirt
Spray on cleaning agent sparingly and allow
to work for 1-5 minutes.
Step 2: To remove dirt
Spray off loosened dirt with the high-pressure
jet.
·
Following operation with cleaning agent, you
should set the cleaning-agent metering valve
to “0”, and spray the appliance clear for
1 minute with the gun open.
5. Operation

5.5 Interrupting Operation

·
When you release the lever of the hand spray
gun, the appliance switches off. It switches
back on again when the lever is pulled once
more.

5.6 Switching off the Appliance

·
Switch off the appliance and pull the electric
plug out of the socket.
·
Close the water inlet.
·
Pull the lever of the gun until there is no more
pressure in the appliance.
·
Secure the gun lever against unintentional
opening by adjusting the hand wheel to “0”.
HD 1000 Si
GB
19