Installation - Hoover HFDN180 Bedienungsanleitung

INTRODUCTION
Before use
Please read these instructions and the Safety
guidelines on page 1 carefully before using your
new Fridge. The Fridge is for indoor, domestic
use only.
Description(
No
1
2 Egg Tray
3 Bottle Rack
4 Refrigerator Glass Shelf
5 Salad Crisper
6 Upper Freezer Drawer
7 Freezer Room Glass Shelf
8 Bottom Freezer Drawer
9 Adjustable Foot
10 Middle Bottle Rack
11 Crisper Cover
12 Bottom Bottle Rack
13 Fresh-keeping lamp

INSTALLATION

Location
When selecting a position for your Fridge you
should make sure the floor is flat and firm, and
the room is well ventilated with an average
room temperature of between 16℃ and 38℃.
Avoid locating your Fridge near a heat source,
eg, cooker, boiler or radiator. Also avoid direct
sunlight in out-buildings or sun lounges. If you
are placing your Fridge in an out-building such
as a garage or annex ensure that the Fridge is
)
Fig. 2
Light
placed above the damp course, otherwise
condensation will occur on the Fridge cabinet.
Never place the Fridge in a wall recessed or into
fitted cabinets or fumiture when your Fridge is
working, the grille at the back may become hot
and the sides warm. It must therefore be
installed so that the back of the Fridge has at
least 9cm(31/2") of free space and the sides
have 3cm(3/4"). Do not drape the Fridge with
any covering.
Leveling the Fridge
If the Freezer is not level, the door and magnetic
seal alignment will be affected and may cause
you Freezer to work incorrectly. Once the
Freezer is placed in its final location, adjust the
leveling feet at the front by turning them.
Cleaning before use
Wipe the inside of the Fridge with a weak
solution of bicarbonate of soda. Then rinse with
warm water using a damp sponge or cloth.
Wash the baskets and shelves in warm soapy
water and dry completely before replacing in
the Fridge. The external parts of the Fridge can
be cleaned with wax polish. See page 9 for more
details on cleaning.
Before plugging in YOU MUST
Check that you have a socket which is
compatible with the plug supplied with the
Freezer. If not see the section called ELECTRICAL
INFORMATION .
Before switching on!
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER
MOVING THE FREEZER.
The coolant fluid needs time to settle. If the
appliance is switched off at any time, wait 30
minutes before switching back on to allow the
coolant fluid to settle.
Before filling your Fridge
Before storing foods in your Fridge, turn the
Fridge on and wait for 24 hours, to make sure it
is working properly and to allow the Fridge to
fail to the correct temperature.
START
Display panel is located at the door of the cold
storage room, interface display as follows:
27