Setting The Volume - Palazzetti WILMA Verwendung Und Betrieb

2.3.3
Display brightness when in standby mode can be set.
a) Use the arrow buttons
b) Use the
c) Use the
d) Set the desired brightness (

2.3.4 Setting the volume

The volume of the buzzer can be set based on requirements:
a) Use the arrow buttons
b) Use the
c) Use the
d) Set the desired volume (OFF, 1 to 5) using the
2.3.5
A good combustion depends on several factors (type of installation, operation and maintenance conditions, type
of pellet etc ..)
If at the end of combustion in the brazier are many waste, it is advisable to change the combustion con gurations
(increasing the value) to nd the most satisfactory solution.
a) Use the arrow buttons
b) Use the
c) Use the
d) Set one of the following values using the
"1"
"2"
"3"
e) Press to con rm the settings.
22
to go to the setup menu
button to select the password "7" and then press
button to scroll to and select submenu
OFF, 1 ... 5
to go to the setup menu
button to select the password "7" and then press
button to scroll to and select submenu [
to go to the setup menu
button to select the password "7" and then press
button to scroll to and select submenu
and then press
and press
[11]
) using the buttons and press
and then press
13 ] and press
buttons and press
and then press
[14] and press
and buttons:
;
to con rm;
to con rm;
to con rm.
;
to con rm;
to con rm;
to con rm.
;
to con rm;
to con rm;