Installation; Installing Loop Handle (02); Installing Guard Plate (03); Installing Spool (04) - AL-KO BC 225 L-S Betriebsanleitung

GB
■
Immediately switch off the ap-
pliance if the engine begins to
vibrate abnormally or strongly.
There is an appliance fault in
this case.
■
Never operate the appliance
with worn or defective parts.
Always replace defective
parts with original spare parts
from the manufacturer. If the
appliance is operated with
worn or defective parts, guar-
antee claims against the man-
ufacturer are excluded.

4 INSTALLATION

WARNING!
Danger if assembly is
not carried out com-
pletely!
Operation of an incom-
pletely assembled appli-
ance can result in serious
injury.
■
Only operate the appli-
ance when it is fully as-
sembled.
■
Check that all safety
and protective devices
are in place and func-
tioning correctly before
switching on.
40
WARNING!
Risk of injury due to de-
taching appliance parts
Appliance parts detaching
during operation can lead
to serious injury.
■
Attach the cutting tools
so that they cannot
come loose during oper-
ation.
4.1

Installing loop handle (02)

1. Place rubber sleeve (02/1) over shaft (02/2).
2. Place loop handle (02/3) from above and
spacer (02/4) from below onto the rubber
sleeve.
3. Insert an Allen screw (02/5) from above and
screw on a nut (02/6) from below, then
tighten slightly. Repeat this step with the
other Allen screws and nuts.
4. Tighten all Allen screws securely.
4.2

Installing guard plate (03)

1. Push a spring lock washer (03/1) and a
washer (03/2) onto the screw (03/3) M5 x
45 mm.
2. Insert both screws with spring lock washer
and washer through front attachment part
(03/4) and position on the shaft (03/a).
3. Position rear attachment part (03/5) and
guard plate (03/6) on the shaft (03/b).
4. Tighten the screws securely.
4.3

Installing spool (04)

1. Hold driver disc (04/1) firmly.
2. Screw spool (04/2) onto the shaft and tighten.
Note: Left-hand thread! Tighten the spool in
anti-clockwise direction!
4.4

Assembling shaft (05)

The shaft of the brushcutter comes in two parts to
save space during storage.
Pushing the two shaft halves together
1. Loosen (05/a) clamping screw (05/1) of upper
shaft half (05/2).
2. Pull fixing pin (05/3) out to unlock (05/b) and
twist to lock.
Installation
BC 225 L-S