Cleaning And Maintenance - Silk'n Fresh H4001 Bedienungsanleitung

a The device is set to switch off automatically after 1 minute. However, if
you change modes during a treatment, the timer will reset to zero and
will start again.
EN

7. Cleaning and maintenance

Use warm water up to a maximum of 45ºC / 113º F.
7.1 Cleaning the brush heads
Clean the brush head after each use.
U
Switch the device off. Rinse with warm water and mild soap to remove
any build-up that may have accumulated. Then shake off any excess
water.
U Dry the brush and the brush head with a towel. You can also dry the
brush head by switching the device back on, and rubbing it against a
towel for 5-10 seconds.
a We recommend you replace used brush heads every 3 months, or earlier
if you see that they are worn.
C
Do not allow face wash to accumulate on the brush heads.
7.2 Cleaning the device and charging cradle
We recommend that you clean the device after each use, and the stand/
charging cradle once a month. Before cleaning:
U
Remove the device from the stand/charging cradle.
U Disconnect the stand/charging cradle from the electricity supply.
U Do not use abrasive cleaners or chemicals to clean any parts.
U Clean the device or stand/charging cradle with a damp cloth using a mild
detergent, then wipe it dry with a clean cloth.
U To remove any residue of face wash around the nipple, remove the
brush head, and wash the nipple and the surrounding area with warm
water. Then wipe it dry with a clean cloth.
C
Do not clean the device or any of its parts in the dishwasher.
12