Control Panel; Sound Emitted By The Beertender; Dispensing Beer - Krups BeerTender VB32 Bedienungsanleitung

English
„ Remove the tap cover by pulling it upward as shown on the drawing -
fig. 14.
Note: this cover can be removed for cleaning.
„ Take the tap of the BeerTender Keg "Compatible BeerTender" and fit it into
place.
Note: Do not try to actuate the tap of the BeerTender Keg by hand.
„ Position the beer tube as shown on drawing - fig. 15.
„ Put the tap cover back in place.
Note: the tap cover cannot be closed if the BeerTender Keg tap is not fitted
properly.
„ Make sure the tap handle is positioned in the tapping mechanism before
the lid is closed.
„ Make sure that the handle is positioned as shown on the drawing to avoid
damaging the beer tube - fig. 16.
„ Carefully close the appliance lid - fig. 17.

CONTROL PANEL

„ Two LEDs on the top of the lid provide important indications:
Green ON LED on the left of the panel: when lit, it indicates that the
appliance is operating - fig. 18.
Green beer-temperature LED on the right side of the panel: when the
BeerTender Keg has reached the ideal temperature the LED switches on
and the appliance goes into "stand-by" cooling mode - fig. 19.
SOUND EMITTED BY THE BEERTENDER APPLIANCE
„ The cooling function of the BeerTender produces sound.
„ The BeerTender features a cooling system which controls the temperature
of the BeerTender Keg. There are two cooling modes:
1. stand-by cooling corresponds to the main operating conditions. In this
mode the cooling fan produces a barely audible noise;
2. active cooling is triggered when temperature inside the cooling chamber
is too high. As soon as the beer keg reaches the right temperature, the
appliance will switch back to stand-by cooling mode.

DISPENSING BEER

Note: always check the "best before end" date shown on the bottom of the
BeerTender Keg. Do not use the BeerTender Keg beyond this date.
Note: the beer must be dispensed into suitable containers; the dispensing
function is started and stopped manually by the user.
26