Appendix: Parameter List - Siko MA05 Benutzerinformation

Appendix: Parameter list

(in English language, parameter _LAn_ = "EnGL")
Display Designation / value range
_rESoL_ resolution: 10,1, 0.1,0.01 (mm)
1 in, 0.1 in, 0.01 in, 0.001in (inch) FrEE
_FAC_ calculating factor:(only if resolution
has been programmed to 'FrEE')
0.00001 ... 2.99999
_CAL_ calibration value: -199999 ... 999999
_OFF_ offset value:
_dP_ decimal point:
(only if resolution has been
programmed to 'FrEE') 0. to 0.0000
_ZAEHL counting direction : UP, dn
_rFS_ switch type on calibr. input: n.o. , n.cl.
_F_SEt reset function enable : on, oFF
_F_rEL incremental measurement function
enable : on, oFF
_F_CAL calibration value enable : on, oFF
_F_OFF offset value enable : on, oFF
_P_S_ delay of
3, 5, 10, 20, 30.
_LAn_ language GEr, EnGL
_ucL_ upper range limit : 0000...5000
_Adr_ address setting Sikonetz 3 : 01...31
_bAud_ interface's baud rate: 300, 600, 1200,
2400, 4800, 9600, 19200, ActuAt, Sn3
_uPL_ upper limit value: (only available with
option 'switched outputs' 'ActuAt')
-199999...999999
_LoL_ lower limit value: (only available with
option 'switched outputs' 'ActuAt')
-199999...999999
1 6 MA05
-199999 ... 999999
key in seconds:
Datum 09.01.2002
Your programming I Your programming II
SIKO GmbH
Dr.-Ing. G. Wandres
Werk / Factory:
Weihermattenweg 2
D-79256 Buchenbach
Postanschrift / Postal address:
Postfach 1106
D-79195 Kirchzarten
Telefon / Phone 0 76 61 / 3 94 - 0
Telefax / Fax
eMail
Internet
Art.Nr. 78211 Z.Nr. 8664063
0 76 61 / 3 94 - 388
info@siko.de
www.siko.de
Änd.Stand 389/01