Technical Data - Proxxon MICROMOT 230/E Gebrauchsanleitung

An ergonomically positioned non-slip soft
component on the forward part of the Micromot
230/E enables the user to exploit all these
advantages and facilitates precision guiding
without fatigue. Even two-fi ngered guiding of
the device presents no problem.
Provisions have also been made for use with
our drill stand or similar accessories, with the
Micromot 230/E incorporating the familiar 20 mm
system fi t in this respect.
3 Scope of delivery:
1 x Micromot 230/E
1 x Operating instructions and safety guide
lines
1 set Steel collets (1 - 1.5 – 2 - 2.4 - 3 and
3.2 mm)

4 Technical data:

Device:
Length:
Weight (without cable):
Shaft neck:
Motor:
Rotational speed:
Voltage:
Capacity:
Short-term operation:
Noise development:
Do not dispose of the electrical device in
household waste!
Please wear hearing protection!
Protection class II device
5 Commissioning:
Your Micromot 230/E is ready to use on
delivery. Apart from clamping the operational
tools, no special commissioning measures are
necessary.
approx. 230 mm
approx. 270 g
ø 20 mm.
6000 to 20000/min
220-240 V
approx. 80 W
KB 5 min
≤ 70 dB (A)
However, please check the device and the
operational tools for any visible wear prior to
every use!
Always ensure your own safety!
Despite its compact size, the Micromot 230/E
is an electric tool that harbours a certain level
of risk. Always ensure that the mains plug is
disconnected when checking the device, during
cleaning or when changing the operational
tools or collet chucks!
5.1 Adjusting the operational tools (Fig. 2)
A collet chuck suitable for a shaft diameter
of 2.4 mm is fi tted ex works to the spindle
collet holder. This is the preferred diameter for
Proxxon operational tools.
Always ensure that the correct collet is used
corresponding to the shaft diameter! Never use
operational tools with a shaft diameter which
does not correspond to the inside diameter of
the collet!
Do not tighten the sleeve nut if a collet without
an operational tool is inserted in the spindle!
All operational tools should be clamped as short
as possible. Excessively protruding shafts can
bend easily and contribute to poor concentricity.
Caution:
Disconnect the mains plug!
1. Press the lock button 1
2. Rotate the spindle with the sleeve nut 2
slightly while pressing the lock button
simultaneously until it engages in the
depression on the spindle.
3. Loosen the sleeve nut
4. Remove the operational tool 3 if necessary
and insert a new one in the collet hole
5. Tighten the sleeve nut 2 while depressing
the lock button.
- 9 -