ABB CoriolisMaster FCB100 Anweisung Seite 28

12 – EN CORIOLISMASTER FCX100, FCX400 SEALING OF DEVICES | IN/FCX100/FCX400/MID/OIML-XA REV. A
Preparation
1
2 3
Fig. 19
1. Loosen two of the four screws
replace with head hole screws
2. Unscrew both fixing screws
cover of the dual-compartment housing and replace
with the holding rods
Lay seal wire
1
Fig. 20
1. Insert locking cylinder
rear housing cover.
2. Insert the seal wire 2
holding rod 1 such that both ends are the same length.
1
2x
5 on the foot and
4 .
1 on the front and rear
3 .
2 3
3 on the holding rod 1
through the openings on the
3. Tightly twist the seal wire
cylinder 3
NOTICE
You should still be able to slightly move the locking
cylinder after it is secured with the seal wire.
2
4. Continue to twist the seal wire
on the front housing cover. Both ends of the seal wire
must be very close together and the twist loops should
3
be smaller than 1 cm.
4
5. Secure the locking cylinder
5
described in step 3.
G12361
1
2
3
Fig. 21
6. Continue to twist the seal wire
hole screw
hole in the screw, guide the other end near the screw.
Tightly twist the seal wire
screw 3
G12352
on the
2 right behind the locking
to secure the locking cylinder
2
on the front cover, as
3
1
3 . Guide one end of the wire through the
1 right behind the head hole
to secure the screw.
3 .
to the holding rod 1
G12354
up to the rear head