Trouble Shooting - Josef Kihlberg R557PN Betriebsanleitung

KUDA PACKAGING
8 8
Before all trouble shooting tasks on
the stapler it must first be
disconnected from the air supply.
FAULT
No staples when firing the tool.
Bad clinch
Jammed staple in the nozzle.
SERVIS A NAHRADNÍ DÍLY
06.14
www.kuda-packaging.com

TROUBLE SHOOTING

TROUBLE SHOOTING
– Check that the right type of staples is being used
and moves easily.
– Always use Josef Kihlberg original staples.
– Clean the staple track.
– Air pressure too low. Secure that working pressure
is as recommended, see chapter 6.6.
– Check if the right leg length is used and the sta-
pler is right adjusted, see chapter 6.1.
– Has the tool been used without oil? Provide lubri-
cation, see chapter 5.2.
– Remove the defective staple, see chapter 7.2.
+420 607 237 237
Josef Kihlberg R557PN
info@kuda-packaging.com
ELIMINATION
servis@josef-kihlberg.eu
13