Intended Use; Ec Declaration Of Conformity; Instruction Manual - Makita DLW140 Betriebsanleitung

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Wheel diameter
Hole diameter
Max. wheel thickness
No load speed
Rated voltage
Dimensions
(L x W x H)
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
• The shape and weight vary depending on the specifications which differ country to country.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.

Intended use

The tool is intended for cutting in ferrous materials with
appropriate abrasive cut-off wheel. Follow all laws and
regulations regarding dust and work area health and
safety in your country.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-3-10:
Sound pressure level (L
) : 115 dB (A)
Sound power level (L
WA
Uncertainty (K) : 3 dB(A)
WARNING:
Wear ear protection.
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841-3-10:
Vibration emission (a ) : 2.5 m/s
h
Uncertainty (K) : 1.5 m/s
With European type safety guard
With safety guard other than
European type
With center cap type safety guard
With European type safety guard
With safety guard other than
European type
With center cap type safety guard
) : 103 dB(A)
pA
2
2
537 mm x 290 mm x 640 mm
537 mm x 280 mm x 640 mm
537 mm x 280 mm x 640 mm
BL1815N / BL1820 / BL1820B / BL1830 / BL1830B / BL1840 /
BL1840B / BL1850 / BL1850B / BL1860B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF
NOTE: The declared vibration emission value has been
measured in accordance with the standard test method
and may be used for comparing one tool with another.
NOTE: The declared vibration emission value may
also be used in a preliminary assessment of exposure.
The vibration emission during actual
WARNING:
use of the power tool can differ from the declared
emission value depending on the ways in which the
tool is used.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
running idle in addition to the trigger time).

EC Declaration of Conformity

For European countries only
The EC declaration of conformity is included as Annex A
to this instruction manual.
6 ENGLISH
DLW140
355 mm
25.4 mm
3 mm
-1
3,800 min
D.C. 36 V
17.2 - 17.8 kg
15.6 - 16.3 kg
15.4 - 16.0 kg