Water Hardness Setting; Safety Blocking - Teka HKS 930 S Bedienungsanweisung

EN
Basic settings

Water Hardness setting

The appliance
automatically indicates when it is time to descale.
The system can be optimised for households with
very soft water (also through using a water
softening appliance) and very hard water, by
changing the user settings to the relevant range of
water hardness (see table below).
Type
Soft water
Medium water
Hard water

Safety blocking

The oven functioning can be blocked (for example, to stop it being used by children).
1
1. To block the oven, press the Stop key (7) for 3
seconds. You will hear a sound signal and the
display will show the "key" symbol. The oven is
blocked in this state and cannot be used.
7
features a system
Ca + Mg English deg.
(ppm)
0 to 150
151 to 350
501 to 500
3
that To set the water hardness parameter, proceed as
follows:
1. Rotate the Rotating knob (1) to the descaling
symbol. "" will start to flash (by default) on
the display (not necessary if your oven is first
plugged in or after a power failure).
2. Turn the rotating knob (2) to set the correct
water hardness parameter value, according to
the below table.
3. Press the OK key (5) to set the parameter. The
display shows the clock.
Water hardness
French deg.
[°eH]
0 to 11 0 to 15
12 to 25 16 to 35
26 to 35 36 to 50
4
5
2. To unblock the oven, press the Stop key (7)
again for 3 seconds. You will hear a sound
signal.
German deg.
[°dF] [°dH]
0 to 8
9 to 20
21 to 28
6 7
Display
1
2
3
2