miniland baby digimonitor 3.5" Bedienungsanleitung Seite 17

link button (VI) of the camera and, if the process has been carried out successfully, the icon will
appear in green
If linking is not successful, the icon
or with another channel if necessary.
For various reasons, connection may be lost between the monitor and a camera already linked.
In this case, repeat the process explained above to relink the camera to the monitor.
5.2.6. CAMERA SETTINGS (Figure 6
You can configure the settings of each camera by accessing the relevant
5.2.6.1. TEMPERATURE ALARM (Figure 7)
With this option you can set the temperature display in ºC or ºF and set an alarm that will alert
you when the temperature in the baby's room is outside the set range.
To set the alarm, first select the maximum and minimum temperature of the range and click on
the icon , which allows you to enable or disable the alarm.
You can also select how long the monitor will emit the alarm signal, from the options available,
by clicking on the icon
To change the temperature unit between Celsius or Farenheit, click on the icon
5.2.6.2. TRANSMISSION POWER/VOLUME (Figure 8)
With this menu you can set the volume level at which the parents' voice is played in the camera,
by using the two-way function. You can choose from 6 levels (0-5) by pressing the + or – signs
as required.
Moreover, from this menu you can change the power level emitted by the camera, by choosing
between the high/low options. When placed in the HI (HIGH) position, it covers a distance 230
meters in open country with the original power. When place in the LOW position, the maximum
distance is reduced to approximately 90 meters in open country and the output power is reduced.
You can also control this feature from the home screen. Click on the icon (j) and this will appear
next to the power level emitted (LO, HI). Changes made directly on the home screen only affect
the camera that is picking up the images displayed.
5.3. TROUBLESHOOTING
Problem
No reception on the
monitor
No images are
displayed but sounds
are heard
in place of the previous one and the LED indicators will light up green.
will appear. In this case, try again with the same channel
.
Possible Cause
Camera not turned on
Monitor not turned on
Camera: not plugged in to the
power adapter
Monitor: The power adapter is
not plugged in or the battery is
low (check LED)
The VOX mode or the MD
mode are active
Monitor out or range
Connection lost between the
monitor and a camera already
linked
Low monitor battery power
(check LED)
)
Solution
Press and hold down button (III) for
2 seconds
Press and hold down the
power button (6)
Plug in the power adapter
Plug in the power adapter or
charge the battery
To see the monitored area
continuously, disconnect the VOX or
MD mode on the monitor.
Move the monitor closer to the
camera
Move the monitor closer to the
camera
Plug in the power adapter
or charge the battery
17
ENGLISH
icon.
.