Programming Mode; Parameter Description - Siko MA502 Software S Originalmontageanleitung

MA502-S
26

Programming mode

5 Programming mode
The display is delivered ex factory with default settings. Normally pro-
gramming is only necessary at initial installation. Parameters can be
modified and checked at any time. They are stored in a non-volatile
memory. For designation, function and selectable values refer to the table
6.1 and 6.2.
in chapter
To change and control parameters
For parameter modification enter into programming mode.
To enter into programming mode
Press key for at least 5 s (pre-programmed) or for the period program-
med under P-KEY delay.
To leave programming mode
No key actuation for at least 30 s, or press key
meter list is reached.
To scroll parameter information
Use key .
To change parameters
Use keys and .
To store/modified parameters
Press key , then message "saving..." will be briefly displayed.

6 Parameter description

For a detailed parameter list containing all parameters that can be set and
the possibility to note down specific configurations refer to chapter 11.
The first selection is made in the menu items LANGUAGE (the term "SPRA-
CHE" will be displayed first in German) and SHOW:
1. Parameter LANGUAGE: = "ger" German (or "deu"), "eng" English.
2. Linear path measurement: Parameter SHOW: = "lin" (see chapter 6.1).
3. Angle measurement: Parameter SHOW: = "angle" (see chapter 6.2).
MA502-S · Date 13.03.2014 · Art. No. 81781 · Mod. status 422/13
English
until the end of the para-