Mounting The Magnetic Tape - Siko MA503/1 Originalmontageanleitung

MA503/1
22 Installation
NOTICE
CAUTION
NOTICE
NOTICE
NOTICE

Fig. 4: Mounting of panel case EG40
Bench housing TF
Max. reach of screw is 5.0 mm!
The rubber feet can be removed to enable the unit to be screwed down.

4.3 Mounting the magnetic tape

External magnetic fields
Magnetic tape's magnetization gets lost. Any direct contact of the mag-
netic tape with magnetic fields (e. g. adhesive magnets or other perma-
nent magnets) is to be avoided. Sensor movements during power loss are
not captured by the follower electronics.
` Protect the magnetic tape from impact by external magnets.
Solving bonding of the magnetic tape
` Remove foreign anti-adhesive substances including oil, grease or dust
by means of detergents that are preferably evaporating residue-free.
Suitable detergents include ketones (acetone) or alcohol offered for
instance as fast cleaning agents by the Loctite or 3M companies.
` For optimum bonding, the surfaces to be bonded must be dry and
bonding shall be carried out with maximum contact pressure.
` Observe a bonding temperature between 20 °C and 30 °C in dry rooms.
Deterioration of measuring accuracy
` Mount the magnetic tape level with the mounting surface or distance
to be measured. Unevenness deteriorates the measuring accuracy.
Length of the magnetic tape
` For technical reasons, the magnetic tape must be 100 mm longer than
the distance to be measured.
MA503/1 · Date 05.09.2016 · Art. No. 80844 · Mod. status 151/16
1
2

English
Panel
max. holding of the
mounting tabs = 5 N