Practical Hints - LauraStar COMPACT Gebrauchsanweisung

MDE Compact 27.8.2001
Angora/Wool
Steam iron about 10 cm from the
surface of the material, in order
not to damage it.
Shake the garment by hand so that
it regains its normal volume.
CAUTION
Using a hot iron with steam under pressure
can cause severe burns.
Special materials
Velvet, Corduroy, Jersey
If you are not using a Teflon® soleplate, steam
iron 1 cm from the surface of the material, then
smooth by hand.

Practical hints

Using the Teflon® soleplate
The Teflon® soleplate must be used for dark materials that are likely to become shiny and synthetic materials that might stick
to the soleplate.
To use the Teflon® soleplate: 1.Place the iron in the soleplate.2.Pull the spring towards the end of the iron as shown in the draw-
ing.Wait for about 1 minute for the soleplate to reach the same temperature as the iron.This avoids droplets of condensation falling
onto the material. Do not forget to remove the Teflon® soleplate after use.
CAUTION: Contact with the Teflon soleplate can cause severe burns and damage nearby objects.
16:08 Page 33
Vertical removal of creases
5
Hand the garment on a coat hanger or
hold it up.
With a sweeping movement from top to
bottom lightly touch the material while
giving short bursts of steam.
Note: It is easy to remove creases from
most materials,except for cotton,linen and
some silks.
If it is difficult to remove the creases from a
material, iron it as normal on the ironing
board.