EdilKamin MYA Installations-, Betriebs- Und Wartungsanleitung Seite 36

Pellet reserve system
Before enabling the system, you need to load a sack of pellets into the tank and use the stove until the loaded
fuel has run out. This allows for a short system road test.
After this, the tank can be lled completely and the stove started up.
When running, at the time at which a whole 15 kg sack of pellets can be loaded, the display will show the word
"Reserve" ashing.
At this point, after having poured in a sack of pellets, you need to 'inform' the memory that you have loaded 15 kg (use the glove
provided).
To do so, proceed as follows:
1. press the "M" key (for approximately 3-4 seconds) until the word "Clock" appears.
2. press the "+" key until the word "Reserve" appears.
3. press the "M" key until the following screen appears,
Kg remaining in tank
then use the "+" key to take the gure (*) to the value equal to the Kg of pellets loaded (15 kg in the above example).
4. press the "M" key to con rm
5. press the key
After having completed the above procedure, after having consumed the 15 kg, the wording "Reserve" will appear
ashing at intervals. After which the operation must be repeated, from point 1 to point 5.
EMERGENCY BUTTON
If the radio control should be faulty, the basic functions can be accessed using a red emergency button on the right side of the
stove (see g. 1).Push this button once or more times to activate the required function:
1. A STOVE OFF
by pressing the red button for 2 seconds this turns on.
2. A STOVE ON
by pressing the red button for 2 seconds this turns off.
3. A STOVE ON
manual mode, by pressing the red button, you go from P1 to P3.
4. A STOVE ON
automatic mode, by pressing the red button, you go from 5°C to 30°C.
INSTRUCTIONS FOR USE
to exit.
- 36
-
Kg caricati
emergency button