Safety Regulations; Cleaning And Maintenance - WAGNER Plast Coat 830 Originalbetriebsanleitung

Plast Coat 830
1

SAFETY REGULATIONS

The following sources are just a sample of those containing
a) EN 12001:2003, Conveying, spraying and placing ma-
chines for concrete and mortar - Safety requirements
All local safety regulations in force must be observed.
The following specifications are to be observed in particular to
Usage of the mortar spraying machine
to process the coating materials described on page 33. Any
other usage is not allowed.
Proper usage also includes the observance of the operating
manual and the observance of the inspection and mainte-
pressure.
Protection of persons
safety goggles, protective clothing, gloves, possibly use
protective skin cream and respiratory equipment. Do
not decouple the mortar hose as long as it is under pressure.
with it.
People not needed to assist with machine installation, assem-
The PC 830 is equipped with an EMERGENCY STOP switch for
emergencies.
Breathing masks
Make a breathing mask available to the processor in order to
protect against mineral dust.
Connection to the mains network only via a special feed-
ing point, for example via a distribution board for con-
struction sites, with residual current protective device
with INF ≤ 30 mA.
Avoid soiling of the socket for the remote control at the
control unit.
wear ear protection.
Risk of injury from escaping material.
Before switching on, always check that the
material tap on the spray lance is closed.
Close material tap whenever stopping
work.
Never operate the mortar spraying ma-
chine if the rotor is exposed or if the con-
tainer has been removed.
Do not reach into the rotor when it is mov-
ing. Risk of crushing.
Caution if you have long hair. Only wear
close-fitting clothes at work.
Do not insert objects or body parts
through the protective grid.
Risk of crushing when folding in the han-
dles, assembling the pump unit and con-
necting the mortar hose.

Cleaning and maintenance

-
Never decouple mortar hose or disassemble machine when
under pressure. Note pressure reading on pressure gauge.
-
high-pressure steam cleaner. Danger of short-circuits caused
Wear
Electrical equipment
tions or scorched cables.
Keep the label on the mortar spraying machine clean and
legible.
Whenever the machine is automatically
brought to a standstill or during power
failure, immediately move the selec-
tor switch to "A" to prevent the machine
starting back up again unintentionally.
There is a danger of injury.
GB
SAFETY REGULATIONS
-
-
31