Set 315 - X Mode Automatic Report Management Set 316 - Z Mode Automatic Report Management - Olivetti CFR3000 Anwenderhandbuch

SET 315 – X MODE AUTOMATIC REPORT MANAGEMENT
SET 316 – Z MODE AUTOMATIC REPORT MANAGEMENT
This function is used to program automatic printing of a number of reports. This
means that with a single operation you can print all the reports programmed at the
same time.
•
SET 315: allows you to program sequential printing in X mode of a maximum of
16 reports (daily + periodic).
•
SET 316: allows you to program sequential printing in Z mode of a maximum of 9
reports (daily only).
The configuration of this function depends on how SET 328 is set. If it is DISABLED
( .0. ) the function is set for daily/periodic, if it is ENABLED (
for periodic 1/periodic 2.
F
03.03.2012 18.10 Till No.: 1
Vch: ON Pr.list 1 Operator: Disabled
4
1 5
6
14 15
11
35
31
28
20
.1. ) the function is set
7
9
17 19
36 29
10
8-11