Manual Adjustment; Electronic Adjustment - Electrolux GA60KV220 Benutzerinformation

2) Do not use salt at this level.
You must adjust the water soften-
er manually and electronically.

Manual adjustment

Electronic adjustment

1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to 'Set-
ting and starting a programme'.
2. Press and hold, at the same time, but-
ton and button
cators of buttons
and start to flash.
3. Press button
•
The indicators of buttons
go off.
6.2 Filling the salt container
Turn the water hardness dial to the posi-
tion 1 or 2.
until the indi-
,
4. Press button
.
5. Deactivate the appliance to confirm
and
1.
2.
3.
4.
5.
• The indicator of button
continues to flash.
• The current setting of the water
softener is indicated by intermittent
acoustic signals and the flashing of
the end indicator.
– E.g. 5 acoustic signals and 5
flashes + pause + 5 acoustic sig-
nals and 5 flashes = level 5.
again to change the setting. Each time
you press the button you select the
next level.
the setting.
Turn the cap counterclockwise and
open the salt container.
Put 1 litre of water in the salt contain-
er (only for the first time).
Fill the salt container with dishwasher
salt.
Remove the salt around the opening
of the salt container.
Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out from
the salt container when you fill it.
Risk of corrosion. To prevent it,
after you fill the salt container,
start a programme.
ENGLISH 57
again and