Legal Disclaimer; Introduction; Software Installation; Creating Connection Via Usb - LD Systems LDDSP44K Bedienungsanleitung

LEGAL DISCLAIMER

In the event of misuse, improper use, or negligent handling of the software, the developer (Adam Hall GmbH) shall not be liable for any
damage to devices of any kind or to any software; this includes personal injury.

1. INTRODUCTION

The LD OCS software (Online Control System) serves to configure LD DSP44K and DSP45K DSP power amps,
load current LD speaker presets, and to create and manage custom speaker and amp presets in 80 storage locations each. At the standard
level, the user can only load speaker presets (e.g. LD speaker presets) and create and manage amp presets (see Section 10. CREATING AND
ADMINISTERING AMP PRESETS). Creating and administering the user's own speaker presets is done at the password-protected user level
(see Section 9. CREATING AND ADMINISTERING CUSTOM). The software is compatible with Windows 7, 8, and 10, and uses either a USB
interface at version 2.0+ or an Ethernet interface for purposes of data connection.

2. SOFTWARE INSTALLATION

Download the LD_OCS_Setup.exe file from the product page at WWW.LD-SYSTEMS.COM and install it to a Windows PC.

3. CREATING CONNECTION VIA USB

Connect the USB port on the LD DSP44K or DSP45K power amp using a suitable USB cable (USB 2.0, USB-A to USB-B) with the USB port on
your PC, and switch on the power amp (the driver may take a moment to install, ATTENTION: A maximum of 1 power amp may be connected
via USB). Now start the LD OCS software and click on the magnifying glass symbol with a plus sign (Fig. 3.1) under Devices. The connected
power amp will now be displayed under Amplifiers with the model number, name, and serial number of the amplifier (Fig 3.2). Now double
click on the power amp model to synchronize the current settings of the power amp with the software (Fig 3.3.).
4
3.1
3.2
3.3